Hunter Humidifier owners manuals:
Most of our hunter humidifier operating instruction questions can be answered in the below text.
1. Remove The Care Free® Humidifier Plus Evaporative Humidifier from its packaging. Read and Save the Instructions.
2. Place the humidifier on a hard, flat, water resistant surface. Always place the humidifier at least six (6) inches away from walls and sources of heat.
3. Lift the main housing to confirm that the PermaWick™ filters are placed upright in the slots. Replace the main housing.
4. Remove the water tank and take it to the sink or tub to fill.
5. Turn the tank upside down and unscrew the tank cap by turning it counterclockwise. Fill the water tank with cool water and replace the tank cap (Never use hot water). Be sure not to overfill the tank as water damage may occur to furniture or flooring due to spillage. HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR DAMAGE TO PROPERTY CAUSED BY WATER SPILLAGE.
6. Carry the tank back to the humidifier. Turn the tank upright and place it on the humidifier. Be sure that the tank is seated properly in the base. If the tank is properly located on the base, you will see air bubbles flowing up into the tank.
7. With the power control knob in the ‘OFF’ position, plug the humidifier into the wall. CAUTION: Never plug in the Humidifier while your hands are wet as Electric Shock could occur.
8. Use the power/speed control knob to turn the humidifier ‘ON’ by selecting a speed setting. Using Your Humidifier Only for models with Automatic Shut-off
9. When the water tank is empty, the humidifier will automatically shut itself off. The red light will be illuminated, indicating that the water tank needs to be refilled.
10. Follow REFILLING THE WATER TANK directions. Once the water tank is refilled, the Refill Light will not be illuminated. Only for models with a NiteGlo™ Night Light
11. Use the control to turn the night light off and on. The night light can be operated even if the humidifier fan is turned ‘OFF’.
Using Your Digital Humidistat Setting the Desired Humidity Note: After unplugging the humidifier to move the humidifier, to refill the water tank or to clean the humidifier, you must reset the digital humidistat.
1. Use the power/speed control knob to turn the humidifier ‘ON’ by selecting a speed setting. Note: A speed setting must be chosen before the humidistat will operate the humidifier.
2. In normal mode use the humidistat control buttons to set the desired humidity level. The settings range from 30% to 80% in 5% increments.
3. When the humidity exceeds the level you have set, the humidistat light will go off. The humidifier will not output humidity while the humidity in the room is at the selected humidity level. The humidistat light will stay off until the humidity changes. When the humidity in the room drops below the selected level, the humidifier will cycle on again and the humidistat light will come on. Setting the Span. Your humidistat is set at the factory to cycle at setting 2. If you find your system cycling too fast or too slow, then the Span can be adjusted to modify the cycle time.
4. Press and hold both humidistat control buttons for two seconds to enter span setting mode.
5. In span mode, use the humidistat control buttons to adjust the span. Raise the span to 3 to increase the cycle time and allow your system to run longer. Lower the span to 1 to decrease the cycle time and allow your system to run shorter.
6. The humidistat display will return to normal mode after keys are idle for 5 seconds.
You will need Adobe® Reader to view these humidifier manuals. A FREE copy can be downloaded by clicking on the logo above.